To Set Up The Dish In Installer Action Mode - Cisco D9865 Installation And Configuration Manual

Chapter 5 Setup and Monitoring via Web GUI
Parameter
LDPC ER
Packet ER
PV BER
RF(1) Power
LNB Status
Click Apply.
Step 5

To set up the dish in Installer Action mode:

Proceed as follows to set up the dish in Installer Action mode:
Step 1 From the Dish Pointing page, click the Installer Action link at the bottom right hand corner of the page.
In the Satellite Number field, enter the satellite number identifying the saved satellite location, as
Step 2
defined by the dish motor manufacturer. You can enter a value in the range from 1 to 255.
From the Installer Action drop-down list, choose the satellite installer action. The following table
Step 3
describes the actions available:
OL-31085-01
Description
Indicates the bit rate of the input stream of the LDPC error
correction stage (DVB-S2 only).
Indicates the current Packet Error Rate.
Indicates the PV (Post-Viterbi) BER for the received signal
(DVB-S).
Displays the LNB Power setting. The LNB Power setting
determines if power is provided via the RF1 Input to an external
LNB connection.
Indicates the current LNB connection status (No Load, Overloaded,
OverTemp, Short Circuit, Disabled, Normal, or N/A).
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
Setting Up Dish Pointing
5-11