Open Loop Soft Stop - Danfoss PVED-CLS User Manual

ENGINEERING TOMORROW
11.7

OPEN LOOP SOFT STOP

The soft-stop function applies to all Open Loop configurations and limits the allowed maximum flow delivered to the
steering cylinders in proportion to the relative wheel angle and is mirrored to both sides (left- and right-end stop). The
function's control algorithm will implement a linear interpolation between two points, Point A and Point B.
•
Point A (1000-P3710, 1000)
•
Point B (1000-P3712, P3708)
1200
1000
800
600
400
200
0
0 100
The range is from 100 to 1000 [IR] for P3708 (i.e. relative soft-stop flow limit).
The range is from 0 to 1000 [IR] for P3710 and P3712 (i.e. relative wheel angle).
The Danfoss recommended values are P3708 set to 200, and P3710 and P3712 set to 0. Soft stop functionality is
disabled with default values.
Important
For wheel angles lower than the one specified at Point A, maximum flow is available.
© Danfoss | August 2018
AUX open loop soft stop
200 300 400 500 600
|Wheel Angle [IR]|
Figure 55
Point A
Point B
700 800 900 1000 1100 1200 1300
AQ00000211 | 107