Upgrading And Pairing Of Sensor-Button Touch - Kindermann Klick & Show Installation And User Manual

The display device shows the home page after normal boot of the device, as shown below.
You can disconnect USB-drive.
4. Perform "Factory Reset"when the firmware update is complete?
Only when the associated "Release notes" are requiring an additional „FACTORY RESET", perform it via the
menu „System Update" / „Factory reset":
all data of configuration will be lost. So that you do not have to re-configure all data in an elaborate
process, therefore note all settings within the Sub-menus before doing Factory reset.
5. The update of Base-unit is finished.
7.3

Upgrading and Pairing of Sensor-button TOUCH

1. Plug the to be updated Sensor-button TOUCH to either of the two USB port of Base-unit. It will
automatically show up a message to indicate if the installed firmware of Sensor-button is older, and needs
to be upgraded.
The upgrading progress starts automatically with the progress bar, as shown below.
63