Kindermann Klick & Show Installation And User Manual page 19

3. Drive in 2 screws. Please leave at least a dimension 0.15mm space to place the bracket between the screw
header and wall.
4. Place the Base-unit on the wall, so that the holes on the bracket matches the 2 unfixed screws on the wall..
Hoop the bracket on the screw and slide the Base-unit downwards until it is fixed in the 2 screw on the wall.
Antenna placement rules
The antennas should be oriented vertically, so perpendicular to the ceiling and parallel to the walls.

The antennas should be installed far enough (at least 50cm/1.6ft) from metallic surfaces to avoid

unwanted reflections and far enough (at least 1m/3.3ft) from other radio equipment that operates in the
same frequency range, e.g. other Wi-Fi access points, cordless telephone, microwave ovens,.... It is also
best to install antennas at least 15 cm (6 inches) from concrete walls.
The most favorable situation is a direct line of sight between antennas and Sensor-buttons TOUCH. Any

obstruction will cause the signal to follow a longer propagation path, which can result in performance
degradation.
Due to the particular radio pattern of the dipole antennas, the antennas should not be placed just above

potential positions of Sensor-buttons users. As a result, the advised position for the obstruction antennas
is at the side of the meeting room.
19