Upgrading Firmware Base-Unit - Kindermann Klick & Show Installation And User Manual

Wireless presentation solution

Hide thumbs Also See for Klick & Show:

Table of Contents

7.2

Upgrading Firmware Base-unit

Please check, if there is a newer firmware available at web-page www.klickandshow.com. If appropriate, then

download the actual firmware.

You need to unzip the file "update.bin" first and copy the updating file to the root directory of the USB

drive.

Connect a HDMI display to Base-unit, HDMI output port, connect a mouse, turn on Klick & Show by press

the front panel power button.

Connect the USB drive to either USB port of Base-unit.

Note: each port can handle max. load of 500 mA.

From Firmware version 2.0.9 or higher Klick & Show recognizes the "update.bin"-file at a plugged-in USB

stick automatically and starts the update-procedure.

Note: You can plug out the USB stick within 10 seconds to stop the update.

Attention !!

Do not disconnect power during upgrading progress. Or, the unit firmware will be corrupted.

The upgrading progress displays as shown below, and the unit will reboot automatically after complete the

updating 100%, as shown below.

Note: During the update, screen can be temporary dark.

If the progress bar stops at 1%, use another USB stick, it may be defective.

Table of Contents