Auto Standby; Airplay Screen Quality; Hdmi Output Resolution - Kindermann Klick & Show Installation And User Manual

Wireless presentation solution

Hide thumbs Also See for Klick & Show:

Table of Contents

5.4.2 Auto Standby

If the Auto Standby mode is activated, Klick & Show will automatically switch to power saving mode, a selectable

time after the last Sensor-button TOUCH was plugged off, WLAN of a mobile unit was disconnected, there is no

active signal at external HDMI-input, or there is no operation at the system. Time is selectable from Never to 30

minutes. In Standby green LED (2) in window of front of Base-unit is flashing and HDMI-output is switched off.

When a Sensor-button TOUCH is plugged in and connected, or a mobile unit is connected, or an active

signal is at external HDMI-input, Standby is deactivated.

Pressing of Power-button or movement of mouse at USB-input at Base-unit deactivates Standby mode also.

Click to select the image quality when transmit apple device by "Airplay" mode, including

High:

1920x1080



Medium: 1280x720



Low:

1136x640.



Note:

Different Airplay quality will occupy different data rate. Under a certain data rage, lower resolution will get better

frame rate.

Select the resolution at HDMI output of Base-unit. When the new resolution can not be displayed, the previous

resolution is displayed after approx. 15 seconds. System will reboot to make changes.

Existing HDMI output resolution:

3840x2160 @60Hz

In AUTO mode Klick & Show automatically switch to the monitor preferred resolution (EDID), when the Base-unit

is booting (Power-key). (One of these four available output resolutions).

3840x2160 @30Hz

1920x1200 @60Hz

1920x1080 @60Hz

Auto

Table of Contents