4.2
Pairing Sensor-button with Base-unit
Connect the USB-connector of Sensor-button TOUCH to either of one USB port of Base-unit, to pair both units at
same WLAN. Follow all OSD messages. A successful pairing is shown at OSD and static red LED.
Then, please disconnect the Sensor-button TOUCH.
Pair all buttons in the same way.
If error-message "Configuration fail" is shown, please check the connection of USB to keep stable after plug-in,
and try again.
Note:
After each changing the SSID/WIFI channel in menu, all the Sensor-buttons TOUCH must be paired again!
27