Kindermann Klick & Show Installation And User Manual page 11

Reset button
On pressing the Reset button, a Hardware-reset is initiated at Base-unit. A „FACTORY RESET", can also be
performed via the menu „System Update" / „Factory reset". Both types will be set the unit back to default.
All data of configuration will be lost. So that you do not have to re-configure all data in an elaborate
process, therefore note all settings within the Sub-menus before doing Factory reset.
Start up the Base-unit.

When the Home screen is shown up, press the reset button at the rear panel of Base-unit. Press this button

with a pointed object, e.g. an unbent paper clip, until the factory reset page is shown up as below, for at least
2 seconds.
The Base-unit will reboot after 3 seconds to be default configuration. All previous settings will be lost and

you will need to do the set-up once more.
After Reset, all Sensor-buttons TOUCH must be paired again to Base-unit, because SSID has changed (see
chapter 4.2).
Default Configuration after Reset
Ethernet

Proxy:
o
IP setting:
o
Tethering & portable hotspot

Portable Wi-Fi hotspot: ON
o
SSID:
o
Security:
o
Frequency:
o
None
DHCP
KlickandShow-xxxx,
WPA2 PSK
5 GHZ
11