Pairing The Base Station With A 60Ghz Receiver; How To Connect Mobile Devices (Android And Ios) - Kindermann QuickPresent air Installation And User Manual

3.1. Pairing the base station with a 60GHz receiver

In deenergized state, the receiver remains paired with the base station. New kits are paired in the factory.
There are two options to restart this pairing (an active image source must be selected first):
Touch the Kindermann logo of QuickPresent air for approx. 3 seconds; this will set any switched-on
receiver within transmission range to pairing mode.
(The Kindermann logo will shortly be blue; this process will take approx. 30 sec).
You can switch to QuickPresent air transmitters already paired with the receiver by pressing
the "Key" push-button on the receiver.
In both cases, the white logo on the base station and the red LED of the receiver will start flashing,
at first slowly, then rapidly.
Remark:
A QuickPresent air transmitter can only be paired with one single receiver at a time. However, each receiver can save
the identifiers of two QuickPresent air transmitters. By pressing the push-button (key) on the receiver, you can switch
between the active transmitters (an image must be available at the input).

How to connect mobile devices (Android and iOS)

Connect your mobile device with the WLAN of the QuickPresent air (SSID and password are displayed in the GUI).
The transmission options (without additional app) depend on the end device:
Mobile devices with Apple AirPlay:
Using Apple AirPlay, you can stream the screen content to the base device.
On iOS devices (iOS4.3 or higher), wipe from bottom to top to display the control centre.
In the control centre, click on the symbol for your Apple device and select the target "DONGLE-xxxxxxx"
(SSID of QuickPresent air) to start the transmission of the desktop.
Mobile devices with Google Android:
On Android 5 or higher devices, the transmission function can be found at different places in the "Settings" menu,
depending on the Android version and manufacturer. In most cases, it is necessary to set the dongle to 5GHz
(see page 8, DIP3).
Only then, the menu item for transmission to an external display is available since it is dynamically displayed
depending on the function of the connected network. Now click on the target "DONGLE--xxxxxxx"
(SSID of QuickPresent air) in the device list to transmit your contents.
Please contact the device manufacturer for further information.
Remark:
This function is not supported by all device-specific Android versions.
* The scope of supply for QuickPresent Air Lite does not include batteries
12