GE Hydran M2-X Instruction Manual page 189

Hydran* M2-X Instruction Manual
SensorCaution OFF Sensor Caution alarm turned off
SensorCaution ON
RTC Bad
SensTstAlr Ack
SetupLost Ack
SetupLost OFF
Set-up Lost ON
Soft WatchDog
Sp Span chg
STempAlr Ack
STempAlr H chg
STempAlr H ON
STempAlr HH chg
STempAlr HH ON
STempAlr L chg
STempAlr L ON
STempAlr LL chg
STempAlr LL ON
STempDelay chg
STemp H OFF
STemp HH OFF
STemp L OFF
STemp LL OFF
STempSetP chg
SystemCalib
TDM Mode chg
Unit in Service
Watchdog
MA-029 Rev. 1.0, 30-Jul-18
Sensor Caution alarm turned on
Real-time clock has failed
Sensor fail alarm has been acknowledged
Setup lost alarm has been acknowledged
Setup lost alarm turned off
Setup lost alarm turned on
Reset of Hydran M2-X induced by the software watchdog
Modification of the sensor temperature set point's range
Sensor temperature fail alarm has been acknowledged
Modification of the sensor temperature High alarm's set
point
Sensor temperature High alarm turned on
Modification of the sensor temperature High-High alarm's set
point
Sensor temperature High-High alarm turned on
Modification of the sensor temperature Low alarm's set point
Sensor temperature Low alarm turned on
Modification of the sensor temperature Low-Low alarm's set
point
Sensor temperature Low-Low alarm turned on
Modification of the sensor temperature alarm's delay
Sensor temperature High alarm turned off
Sensor temperature High-High alarm turned off
Sensor temperature Low alarm turned off
Sensor temperature Low-Low alarm turned off
Modification of the sensor temperature set point
Calibration of Hydran M2-X
Modification of the TDM signal's operating mode
Hydran M2-X back in service after the battery was
disconnected
Reset of Hydran M2-X induced by the hardware watchdog
Page 189