Lightspeed Redcat Access User Manual page 47

FCC Notice to user
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
•Reorient or relocate the receiving antenna (that is, the antenna for radio or television that is receiving" the
interference).
•Reorient or relocate and increase the separation between the telecommunications equipment and receiving
antenna.
•Connect the telecommunications equipment into an outlet on a circuit different from that to which the receiving
antenna is connected.
•Consult the dealer or an experienced radio/TV technician for help.
English:
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter. No change to the antenna
or the device is permitted. Any change to the antenna or the device could result in the device exceeding the
RF exposure requirements and void user's authority to operate the device.
French:
NOTE IMPORTANTE: Pour se conformer au règles d'exposition des ondes RF par la FCC, la (ou les) antenne(s)
utilisée(s) par ce transmetteur doivent être installées de façon à être séparée d'une distance d'au moins
20 cm de toute personne et ne doit pas être utilisée près ou en conjonction avec aucune autre antenne ou
transmetteur. Aucune modification à l'antenne ou à l'appareil n'est permise. Toute modification à l'antenne
ou à l'appareil peut résulter que l'appareil excèdera l'exposition aux ondes RF règlementaires et ainsi annuler
le droit à l'usager d'utiliser l'appareil.
FCC RF Radiation Exposure Statement
This device (Access Link) complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and operated with a minimum distance of 20cm between the
radiator (Access Link) and any part of your body.
For body worn operation, the portable part (Flexmike) has been tested and meets FCC RF exposure guidelines.
This device must not be co-located or operating in conjunction with any other antenna or transmitter. The
changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Notice to Canada User
English
This device complies with Industry Canada licence exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
French
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisee aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement
47