Set-Up And Charging The Flexmike - Lightspeed Redcat Access User Manual

SET-UP & CHARGING THE FLEXMIKE
Before use, the Flexmike should be charged. It will take 8-9 hours for the Flexmike
to obtain a full charge. A fully charged Flexmike will last for up to 8 hours of use. If
microphones are used daily, they should be charged each night.
When properly inserted into a cradle charger, the Mic 1 or Mic 2 light will glow blue and
the red light on the Flexmike power button indicates the battery pack is charging. The
power button light will glow green to indicate that charging is complete and a full charge
has been reached.
Replacement NiMH battery packs may only be purchased through Lightspeed
Technologies (part # NH2.4V). Do not attempt to charge with other battery packs. They
can overheat and expand creating a significant hazard and damaging the microphone
(this is not covered by warranty).
1. Hang the Flexmike on the lanyard
opposite the magnetic clasp.
2. Plug power cord into the cradle
charger and then plug the AC end into
an electrical outlet.
3. Place the Flexmike into the cradle.
(Figure 1) The LED on the Flexmike
power button will glow red indicating
charging has started. The Mic 1 or Mic
2 light will glow blue. (Figure 2)
4. When charging is complete, the power
button will glow green.
NOTE: If Activate Station was purchased
with your system, please refer to page 24 for
charging instructions.
12
(Figure 1)
(Figure 2)