Battery Status Led - Bosch B9512G-E Installation Manual

Control Panels
Non-power-limited wiring
Callout ᅳ Description
1 ᅳ Conduit required for use with external batteries
2 ᅳ Battery wires
3 ᅳ 0.25 in (6.4 mm) minimum. To ensure proper spacing, use tie-wraps or similar devices to
secure wires.
4 ᅳ Output wires
5 ᅳ Sensor loop wires
6 ᅳ 12 V sealed lead-acid rechargeable battery (D126/D1218)
Charging the battery
1.
2.
3.
6.1.2

BATTERY STATUS LED

The control panel includes one BATTERY STATUS LED with 4 LED patterns to indicate the
battery status.
Bosch Security Systems, Inc.
2
1
3
4
Connect the battery
Connect the transformer.
Allow the control panel to charge the battery while you complete the installation.
BATTERY STATUS
Off: Normal
On: Missing
Quick Flash: Low
Slow Flash:
Charging
Low 12.1 VDC
Load Shed 10.2 VDC
Do not connect
to a receptacle
controlled by
a switch.
CLASS 2
1
16.5 VAC 40 VA 60 Hz
2 TRANSFORMER
All exte
3 + AUX POWER
Require
POWER SUPPL
The Power S
-
4 BATTERY ( )
refer to the B
Battery: Replace every 3 to
5 BATTERY ( + )
5 years with one or two
Model D126 or D1218 12V
Lead Acid Batteries.
OUTPUT
6
A (1)
The system is intended
panel has been approv
RevPol.
OUTPUT
7
B (2)
WARNING!
To prevent risk of shock,
OUTPUT
disconnect AC power and
8
C (3)
communication lines before
servicing.
9 COMMON
ON-BOARD POINTS
10 EARTH GROUND
WARNING! WARNING!
Multi-Battery Incorrect wiring will
installation requires damage this
Model D122 or D122L equipment.
Point 1
Dual Battery Harness. Devices powered by
Improper installation any output must be
can be a fire hazard . supervised.
11
USB POWER B
A
STATUS
L
S
I
E
N
K T
POINT 1 COM POINT 2 POINT 3 COM POINT 4
USB ETHERNET
6
Installation Manual
Power supply | en
Owner I
be removed by
Voltage Ranges: Open 3.7 - 5.0 VDC,
1 k End-of-line-Resistors Required (P/N 15093130-004),
Point 3 Point 4
Point 2 Point 5 Point 6 Point 7 Point 8
12 13 14 15 16 17 18 19 20 21
POINT 5 COM POINT 6 POINT 7 COM POINT 8
5
2018.07 | 10 | F.01U.303.996
37
22