Diagnostic Leds - Bosch B9512G-E Installation Manual

Control Panels
Installing the module
1.
2.
3.
Wiring the antenna
1.
2.
3.
Wiring to the control panel
Use either the terminal strip labeled with PWR, A, B, and COM on the module to wire to the
SDI2 terminals labeled on the control panel, or use the interconnect wiring connector and the
included interconnect cable.
For terminal wiring, use 18 AWG to 22 AWG (1.0 mm to 0.6 mm) wire.
Notice!
Use either the terminal strip wiring or interconnect wiring to the control panel. Do not use
both. When you connect multiple modules, you can combine terminal strip and interconnect
wiring connectors in parallel.
8.4.4

Diagnostic LEDs

The module includes the following on-board LEDs to assist with troubleshooting:
–
–
–
The plug-in module also includes LEDs for troubleshooting and status.
Flash pattern
once every 1 second
3 quick flashes every 1 second
Bosch Security Systems, Inc.
Set the module address.
Hold the module mounting brackets onto the inside of the enclosure. Match the bracket
holes to a 3-hole mounting pattern on the enclosure
Use the supplied mounting screws to secure the module.
Secure the antenna cable to the outside of the enclosure.
Route the antenna cable through a wire knockout in the top of the enclosure.
Connect the antenna cable to the cellular module.
MOD-2
MODULE RELEASE
MOD-1
30 29
PWR+/R PWR+/R
29 28
A/Y A/Y
olice olice
27 28
B/G B/G
ting ting
COM/B COM/B 27 26
ire ire
PWR+/R PWR+/R 26 26
A/Y A/Y
25 25
B/G B/G 24 24
COM/B COM/B
23 23
Heartbeat (system status)
RX (receive)
TX (transmit)
R
Y
G
B
Indication
Normal state.
Flashes
Communication error state. Error on the bus
between the module and the control panel.
Installation Manual
IP communications | en
MOD-2
MODULE RELEASE
MOD-1
PWR+/R PWR+/R 29 30
A/Y A/Y 28 29
olice olice
B/G B/G 27 28
ting ting
COM/B COM/B 26 27
ire ire
PWR+/R PWR+/R 26 26
A/Y A/Y 25 25
B/G B/G 24 24
COM/B COM/B 23 23
2018.07 | 10 | F.01U.303.996
55
R
Y
G
B