B600 Retrofit Zonex Module; Installation And Control Panel Wiring (B600) - Bosch B9512G-E Installation Manual

Control Panels
Wiring the devices
Callout ᅳ Description
1 ᅳ B299
2 ᅳ POPIT device
3 ᅳ POPIT address switches
4 ᅳ POPIT sensor loop
5 ᅳ 33 kΩ EOL resistor (P/N: 15-03130-022)
13.3

B600 Retrofit ZONEX Module

The B600 Retrofit (ZONEX) module enables the use of ZONEX devices on the B9512G/
B8512G. The B600 module connects to the control panel through a proprietary connection
(cable provided with module).
The control panel supports one B600.
13.3.1

Installation and control panel wiring (B600)

Calculate power consumption
Make sure that there is enough power for the module and the other powered devices that you
want to connect to the system.
Refer to On-board outputs, page 65.
Caution!
Remove all power (AC and battery) before making any connections. Failure to do so might
!
result in personal injury and/or equipment damage.
Installing the module
1.
2.
3.
Bosch Security Systems, Inc.
2
3
1
- -
+
+
(-)
(-)
(+)
(+)
For retrofit applications, remove the terminal strip from the module.
Hold the module mounting brackets onto the inside of the enclosure. Match the bracket
holes to a 3-hole mounting pattern on the enclosure
Use the supplied mounting screws to secure the module.
2
4
5
- -
+ +
Installation Manual
Off-board points | en
(-)
(-)
(+)
(+)
2018.07 | 10 | F.01U.303.996
81