Recent Closing; Accessories - Bosch B9512G-E Installation Manual

20 en | System overview
A standard system user must have a passcode, a credential (token or card), and appropriate
command authority permissions assigned in the door to the assigned area of the keypad.
When enabled at a keypad, only the following Passcode Functions require access credentials
with passcode entry:
–
–
–
–
Notice!
Plan ahead
If you plan to use Dual Authentication with access control, install a keypad close to the door
controller.
3.3.12

Recent closing

If a point with a point type set to 1, 2, or 3 goes into alarm within 2 minutes after the exit
delay expires, the control panel sends a Recent Closing Alarm. This feature is always enabled
and cannot be configured. The alarm with recent closing event creates new Modem4
messages that the central station might need to add to their automation software. For details
of central station data changes, refer to Events in the Modem4/ModemIIIa
the Appendix in the Conettix D6600/D6100i Computer Interface Manual (P/N: 4998122703).
3.4

Accessories

Accessory compatibility
The following table lists accessories that are compatible with the control panel. An X in a
column indicates the accessory is compatible with the standard.
Notice!
Where the fire alarm transmitter is sharing on-premise communications equipment, the
shared equipment must be UL Listed (ITE or fire protective signaling).
Model
number
B915/B915I* X
B920* X
B921C* 1 X
B925F* X
B926F*
B930* X
B942/B942W* X
2018.07 | 10 | F.01U.303.996
Turn On/Turn Off
Cycle Door (Grant Access)
Cycle Output
Auto Re-arm
X X
X X
X
X X X
X
X X
X X
Keypads
X X X X
X X X X
X X X X
X X X X
X
X X X X
X X X X
Installation Manual
2 Messages section of
X X X X
X X X X
X
X X X X
X
X X X X
X X X X
Bosch Security Systems, Inc.
Control Panels
X
X
X
X
X
X