Rps > [2] Rps Phone Number Menu Parameters; Rps > [3] Rps Ip Address Menu Parameters; Rps > [4] Rps Port Number Menu Parameters - Bosch B9512G-E Installation Manual

Control Panels
20.1.10 [3] RPS > [2] RPS Phone Number menu parameters
The RPS Phone Number is the number the control panel dials to contact RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the RPS phone number.
RPS Phone Number
1.
2.
3.
4.
5.
6.
20.1.11 [3] RPS > [3] RPS IP Address menu parameters
The control panel can use a network hostname or an IPv4 address to call RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the IPv4 address or hostname for RPS or Installer Services Portal
programming tool communication.
RPS IP Address
1.
2.
3.
4.
5.
6.
20.1.12 [3] RPS > [4] RPS Port Number menu parameters
In this menu, you can specify the destination port for outgoing RPS or Installer Services Portal
programming tool (available in Europe, Middle East, Africa, and China) session requests to the
specified IP address.
RPS Port Number
1.
2.
3.
4.
5.
6.
Bosch Security Systems, Inc.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [2] RPS Phone Number.
Press Edit or Enter to edit the RPS phone number.
Delete the existing number, if necessary, and then enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [3] RPS IP Address.
Depending on keypad model:
Press Edit as IPv4 for an IP address, or Edit as Name for a hostname.
-or-
Use Previous or Next to toggle between the option to edit the address as an IPv4
address or as a hostname. Press Enter when the keypad shows the option you want to
edit.
Delete the existing characters, if necessary, and enter the new characters. For an IPv4
address, use /Previous or
keys to enter the new numbers. For a hostname, press a number key repeatedly to scroll
through the number and letters shown on the key.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
Enter the installer passcode, and then open the [1] Installer Menu.
Go to [1] Programming Menu > [3] RPS > [4] RPS Port Number.
Press Edit or Enter to edit the RPS port number.
Delete the existing number, if necessary, and then enter the new number.
Press Save or Enter. The keypad shows Parameter saved.
Escape from the menu.
/Next to move to a different byte, and use the number
Installation Manual
Keypad Installer menu | en 139
2018.07 | 10 | F.01U.303.996