Address Settings; Supervision; Installation And Control Panel Wiring (Keypads) - Bosch B9512G-E Installation Manual

60 en | Keypads, keyswitches, keyfobs and transmitters
For more information, refer to RPS Help or to the Installer Services Portal programming tool
(available in Europe, Middle East, Africa, and China) Help.
9.1.4

Address settings

The control panel uses the keypad's address setting for communication and bus supervision.
If multiple keypads reside on the same system, each keypad must have a unique address even
when on different buses.
B94x/B93x/B92x keypads
B93x and B92x keypads use two hardware address switches. The B94x keypads use two
virtual (on-screen) switches that mimic the hardware switches. For single-digit addresses 1
through 9, set the tens switch to 0. The figure shows the keypad switches set to 1:
B91x and SDI keypads
B91x and SDI keypads use dip switches to set the address. For more information, refer to
B91x address settings, page 168 and SDI keypad address settings, page 170.
9.1.5

Supervision

The control panel supervises all enabled SDI2 keypads.
The control panel supervises SDI keypads when you enable the Supervision parameter (within
KEYPADS\Keypad Assignments) in RPS or in the Installer Services Portal programming tool
(available in Europe, Middle East, Africa, and China).
If the control panel does not receive an expected response from a keypad, all keypads in the
system show a missing keypad error. You can configure the control panel to sends a keypad
missing report to the central station.
9.1.6

Installation and control panel wiring (keypads)

Calculate power consumption
Make sure that there is enough power for the module and the other powered devices that you
want to connect to the system.
Refer to On-board outputs, page 65.
Installing a keypad
1.
2.
3.
4.
5.
Wire to the control panel
For maximum wire lengths, refer to the SDI2 Bus and SDI Bus sections of the table in
Specifications, page 159 and the installation instructions for each keypad.
SDI2 keypads
Connect SDI2 keypads to the SDI2 bus by parallel wire run from the control panel to each
keypad, wire from keypad to keypad, or a combination of the two.
SDI keypads
Connect SDI keypads to the SDIx bus by parallel wire run from the control panel to each
keypad, wire from keypad to keypad, or a combination of the two.
2018.07 | 10 | F.01U.303.996
Open the keypad.
Set the keypad address using the address switches
Use the provided anchors and screws to mount the keypad base on the wall.
Pull the necessary wiring through the mounting plate. Refer to Wire to the control panel.
Install the keypad on the base.
Installation Manual
Control Panels
Bosch Security Systems, Inc.