Local Programming - Bosch B9512G-E Installation Manual

Control Panels
Flash pattern
Tab. 8.4: Heartbeat LED descriptions
Flash pattern
RX (Receive) Flashing
TX (Transmit) Flashing
Tab. 8.5: RX and TX LEDs descriptions
LINK (yellow) LED pattern
Flashing
Flashing
Tab. 8.6: Ethernet Link LEDs descriptions
8.3.6

Local programming

Use the B426 IP Direct connect feature to locally connect with RPS or the Installer Services
Portal programming tool (available in Europe, Middle East, Africa, and China).
Connecting the B426 to RPS or the Installer Services Portal programming tool using IP
Direct
1.
Bosch Security Systems, Inc.
Off
Off
On Steady
On Steady
If the module does not use the Ethernet for IP communication, skip to the next step. If
the module does use the Ethernet for IP communication, power down the module and
remove the Ethernet cable that connects it to the network.
Function
LED trouble state. Module is not powered, or some other
trouble condition prohibits the module from controlling the
heartbeat LED.
Function
Occurs when the module receives a message over the
network connection – UPD, TCP, or DNS.
Occurs when the module sends a message over the
network connection – UPD, TCP, or DNS.
100Mb (green) LED pattern
Off
Off
Off
On Steady
On Steady
Installation Manual
IP communications | en
Function
No Ethernet link
10Base-T link
10Base-T activity
100Base-TX link
100Base-TX activity
2018.07 | 10 | F.01U.303.996
53