Install Driftwood Kit 1101Dwk (1100 Models) - Valor 1100IN Installation & Owner's Manual

Install Driftwood Kit 1101DWK (1100 models)

Material required
• Long Beach Driftwood Kit, which contains:
•
3 logs
•
5 pebbles
•
1 x 1.5 lb bag of 3/4" grey/black shale
• Gloves, if desired
Installation
Logs
Carefully unpack the kit.
Each log has pegs to help you locate them on the
ceramic burner platform. Install the logs as shown
below.
1. Place the left log on the left side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. NOTE: There are two holes for the
front peg of this log depending which type of gas is
used for the appliance.
NG  re: Place the
log's front peg in the
hole closest to the
center of the fi rebox
for natural gas (NG)
fi re. The log covers
both holes.
LPG  re: Place the
log's front peg in the
hole closest to the left
side wall for propane
gas (LPG) fi res.
Installation
2. Place the right log on the right side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. The rear end of the log rests on the
pilot shield. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
NG  re: Place the
log's pegs in the holes
closest to the center of
the fi rebox for natural
gas (NG) fi re.
LPG  re: Place the
log's pegs in the holes
closest to the right side
wall for propane gas
(LPG) fi res.
3. Place the center log inserting its front end peg in
the hole in the front of the burner and resting its rear
end in the slight depression on top of the left log.
QUALIFIED
INSTALLER
53