Install Driftwood Kit 700Xdwk - Valor G3.5 Installation Manual

Installation

Install Driftwood Kit 700XDWK

Material required
• Driftwood Kit, which contains:
• 3 logs
• 4 pebbles
• 2 bag of ash ember grey
• 1 bag of splinters grey
• Gloves, if desired
Installation
Ember and Splinters
Fill the recessed cavity of the ceramic burner with one
layer of ember and splinters provided. NOTE: Ensure
the area within the pilot shield is clear of ember or
splinter pieces.
Logs
Carefully unpack the kit.
Each log has pegs to help you locate them on the
ceramic burner platform. Install the logs as shown
below.
1. Place the left log on the left side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner.
IMPORTANT: Use only the embers and splinters ap-
proved for use with your Valor fi replace. Use of other
media can damage your fi replace and void the war-
ranty.
2. Place the right log on the right side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner.
3. Place the center log inserting its front end peg in the
hole in the front of the burner and resting its rear
end in the slight fl at part on top of the left log.
Pebbles
Place the pebbles on the embers and platform as
shown below. Some embers can be put on the platform
as well.
WARNING
Choking Hazard! Ensure that the fireplace
area is clear of embers & splinters as
these could be ingested by small children.
Vacuum area after installation.
Liners
19