Install Driftwood Kit 1101Dwk - Valor G4 Series Installation & Owner's Manual

Install Driftwood Kit 1101DWK

Material required
• Long Beach Driftwood Kit, which contains:
•
3 logs
•
5 pebbles
•
1 x 1.5 lb bag of 3/4" grey/black shale
• Gloves, if desired
Installation
Logs
Carefully unpack the kit.
Each log has pegs to help you locate them on the
ceramic burner platform. Install the logs as shown
below.
1. Place the left log on the left side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
Natural gas fi re: Place the log forward in the
fi rebox for natural gas fi re.
Propane gas fi re: Place the log rearward in the
fi rebox for propane gas fi res.
Propane
gas
Installation
Natural gas
2. Place the right log on the right side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. The rear end of the log rests on the
pilot shield. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
Natural gas fi re: Place the log forward in the
fi rebox for natural gas fi re.
Propane gas fi re: Place the log rearward in the
fi rebox for propane gas fi res.
Natural gas
3. Place the center log inserting its front end peg in
the hole in the front of the burner and resting its rear
end in the slight depression on top of the left log.
QUALIFIED
INSTALLER
Propane gas
31