Install Driftwood Kit 1101Dwk - Valor LEGEND G4 785XN Installation And Owner's Manual

Install Driftwood Kit 1101DWK

Material required
• Long Beach Driftwood Kit, which contains:
•
3 logs
•
5 pebbles
•
1 x 1.5 lb bag of 3/4" grey/black shale
• Gloves, if desired
Installation
Logs
Carefully unpack the kit.
Each log has pegs to help you locate them on the
ceramic burner platform. Install the logs as shown
below.
1. Place the left log on the left side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
NG fi re: Place the log forward in the fi rebox for
natural gas (NG) fi re.
LPG fi re: Place the log rearward in the fi rebox for
propane gas (LPG) fi res.
LPG
Installation
NG
2. Place the right log on the right side of the ceramic
burner inserting the two pegs of the log in the holes
of the burner. The rear end of the log rests on the
pilot shield. NOTE: There are two sets of holes for
this log depending which type of gas is used for the
appliance.
NG fi re: Place the log forward in the fi rebox for
natural gas (NG) fi re.
LPG fi re: Place the log rearward in the fi rebox for
propane gas (LPG) fi res.
NG
3. Place the center log inserting its front end peg in
the hole in the front of the burner and resting its rear
end in the slight depression on top of the left log.
QUALIFIED
INSTALLER
LPG
29