Using Xtool; Custom Osd - RGBlink M2 User Manual

6.3 Using XTOOL

M2 equips the XTOOL, which is for upgrade, OSD Set, Effect Change, Logo and STILL settings. The
files can be saved to the USB disk, and be loaded after custom the OSD, MASK, LOGO and STILL.

6.3.1 Custom OSD

Double click the icon to enter to the XTOOL interface, select "Toolbox", and enter to the window
as follows:
Follow the steps below:
Tick OSD ON/OFF.

Set the parameters as needed.

Note:
- Up to two lines of OSD can be displayed on a page at a time.
- The font settings can be saved in the PC, and can be reused without another editing.
After editing, load the OSD into the device. There are two ways to load.
(1) Load OSD directly with LAN cables.
- Change the COM No. of XTOOL according to the COM No. of the PC ([Management]).
If an exclamation mark appears in the COM, restart the PC.
- Click [Save To Device].
(2) Load OSD with USB
- Click [Save to Computer] and save in order (0~199).
Chapter 6: Appendix
66