Table of Contents
Advertisement
Chapter 6: Appendix
2.2.1.4.3 User should reboot the device after upgrade, otherwise, it will misidentify the
CORE_PGM and CORE_PVW version.
Method 3: Upgrade with network cable (UDP)
2.2.2.1 Sets the IP addresses of M2 and the computer in the same network segment. Default IP
address is 192.168.0.100 for M2. Right click "Network"→"Properties"→"Local Connection"
→"Internet protocol version 4 "→"Set IP address" on the computer.
2.2.2.2 Double click the icon
and enter to the upgrade tool interface. Select "Connection",
it will pop up the "Connect Set" diagram. Select "Net Comm", as shown in the figure below:
63
Advertisement
Table of Contents
Need help?
Do you have a question about the M2 and is the answer not in the manual?
Questions and answers