System Menu; Factory Reset Menu - RGBlink M2 User Manual

3.3.8 System Menu

->Take Mode
Show the version of COM, PVW MCU, PVW FPGA, PST+PGM MCU,
PST+PGM FPGA, Optional In 1 MCU, Optional In 1-1 Video, Optional In
Version 1-2 Video, Optional In 1-3 Video, Optional In 2 MCU, Optional In 2-1
Video, Optional In 2-2 Video, Optional In 2-3 Video, Optional In 3 MCU,
Optional In 3-1 Video, Optional In 3-2 Video, Optional In 3-3 Video
Enable or disable the network function. If select "ON", user can set the IP
Ethernet
address, subnet mask and gateway.
Step 1: Press the T-BAR to the top.
T-BAR Step 2: Choose ON.
Calibration Step 3: Press the T-BAR to the bottom.
Step 4: Choose ON.
Key Board Test Enable or disable the LED Light Test function and adjust the key value.
Fan Control Enable or disable the Auto Speed. Check the current speed and temperature.
Take Mode Swap or Stay can be selected.

3.3.9 Factory Reset Menu

->Factory Reset
Factory Reset Select "YES" or "NO". Select "YES" to restore default settings.
Factory Reset, Select "YES" or "NO". Select "YES" to restore default settings, but the IP
Save IP information remains unchanged after reset.
Version
Ethernet
T-BAR Calibration
Key Board Test
Fan Control
Factory Reset, Save IP
Chapter 3: Using Your Product
>>
>>
>>
>>
Swap
>>
>>
22