Table of Contents
Advertisement
3.6 Switching Layers
User can use T-bar, CUT or TAKE to switch layers between PGM and PST.
T-bar: Switch the PST layer PST to PGM; user can set the transition duration. The transition effect
can be paused or played back by pushing T-bar.
CUT: Quick seamless transition. Transition effect is NOT displayed.
TAKE: A button to switch layers between PGM and PST. The transition effect is displayed.
Note:
There are two TAKE modes: SWAP and STAY. Follow the steps as below:
(1) Press the MENU button, turn to Page 2:
->System
(2) Select <System>, and enter to the menu items:
->Take Mode
(3) Turn to Page 2, select [Take Mode].
If SWAP is selected, the PST layer and PGM layer is swapped after pressing the CUT, TAKE button
or using T-bar.
Language
Factory Reset
Version
Ethernet
T-BAR Calibration
Key Board Test
Fan Control
Chapter 3: Using Your Product
EN
>>
>>
>>
>>
>>
>>
Swap
37
Advertisement
Table of Contents
