Recall Saved Settings - RGBlink M2 User Manual

3.11 Recall Saved Settings

M2 provides 36 banks for saving or recording parameters. To recall saved settings:
1. Press the LOAD button in Stored Presets Area, the button lights of LOAD and PAGE are lit, and
some of buttons 1~6 are lit and some are flashing. The button lit is ready for recall and the
button flashing means it's being recalled. Press the button lit to recall.
->PAGE: 1
2. Select PAGE, for example, the button [2] is lit, press the button [2].
->PAGE: 2
3. After setting the PAGE, it will jump to BANK option, for example, the button [2] is lit, press the
button [2]:
->BANK: 2
4. Press the LOAD button again, the button light is off, and exit the LOAD function.
5. Select <Load From U Disk>, user can load the saved parameters from the U Disk.
Note:
In Normal mode, data can be only loaded to PST without affecting PGM. It's convenient for users
to save data in advance, and fast recall and transition can be achieved as needed.
LOAD FROM
BANK: 1
Load From U Disk
LOAD FROM
BANK: 1
Load From U Disk
LOAD FROM
PAGE: 2
Load From U Disk
Chapter 3: Using Your Product
No U Disk
No U Disk
No U Disk
48