Removing A Power Module - HP A6616 Installation Manual

The A6616 supports online insertion but not online removal of a power module.

Online refers to first switching off the power module and then removing it from the router or

inserting it into the router. Before doing that, make sure that the router is configured with
redundant power modules and the system services are running normally.

Removing a Power Module

The following describes how to remove an AC power module. You can remove a DC power
module in a similar way.
Step1 Face the front panel of the router.
Step2 Locate the power module to be removed, and loosen the two captive screws on the power
module counterclockwise with a Philips screwdriver.
Figure 4-56 Loosen the captive screws
Step3 Gently pull the power module out along the slide rails.
Figure 4-57 Pull out the power module
To protect the removed power module, place it in an antistatic bag.

If you do not install a new power module in the slot, install a blank panel to prevent dust from

entering the chassis. For how to install a blank panel, refer to
Panel" on page 4-38.
"Installing and Removing a Blank