HP A6616 Installation Manual page 34

LED
Slots
FIP-210s can be inserted in Slot 0 through Slot 3 and Slot 6 through Slot 9 on the A6616. The
interface module slots on a FIP-210 are numbered 1 and 2 from right to left, as shown in
1-25.
Figure 1-25 Interface module slots on the FIP-210
The numbers 1 and 2 in

If only one MIM module is to be inserted into the FIP-210, it should be inserted into Slot 2

because only this slot has a connector.
Maximum interface modules provided by FIP-210s in full configuration
Table 1-28 Maximum interface modules provided by FIP-210s in full configuration
Interface module
FIP-210
MIMs
HIMs
Detailed Descriptions of FIPs
Ethernet interface introduction
The FIP of the router provides two Combo interfaces, each of which consists of an electrical
Ethernet interface and an optical Ethernet interface. The default operating interface is the
electrical Ethernet interface.
For the rate and duplex mode when the electrical Ethernet interface is operating, see

29.
Table 1-29 Rate and duplex mode when the electrical Ethernet interface is operating
10 Mbps
100 Mbps
1000 Mbps
The electrical Ethernet interface LEDs are above the RJ-45 connectors. The LEDs in triangle
and inverted triangle indicate the status of the lower and upper electrical Ethernet interfaces,
respectively. For the description of the electrical Ethernet interface LEDs, see
1-21, Table 1-24, and
The optical Ethernet interface supports 1000 Mbps in full-duplex mode. The optical Ethernet

interface LEDs are on the left of the two Combo interfaces and use separate LEDs to indicate
the status of the corresponding optical Ethernet interfaces. For the description of the optical
Ethernet interface LEDs, see
Status
Blinking yellow
Figure 1-25 represent Slot 1 and Slot 2 respectively.
One RPE-X1
8
16
16
Rate
Table 1-27.
Table 1-18, Table
Data is being received or transmitted at a rate of 10/100 Mbps.
Two RPE-X1s
8 8
16 16
16 16
Half/full-duplex auto-negotiation
Half/full-duplex auto-negotiation
Full-duplex
1-21, Table 1-24, and Table
Meaning
Figure
One RSE-X1 Two RSE-X1s
7
14
14
Table 1-
Duplex mode
Table 1-18, Table
1-27.