HP A6616 Installation Manual page 27

MIM
Dimensions (H × W × D) Dimensions (H × W × D)
Hardware encryption
Power consumption
hot-swapping
For a Combo interface, the default operating interface is the electrical interface. For a Combo interface, the default operating interface is the

For a Combo interface, you can use either the electrical Ethernet interface or the optical For a Combo interface, you can use either the electrical Ethernet interface or the optical For a Combo interface, you can use either the electrical Ethernet interface or the optical

Ethernet interface. You can use the combo enable { copper | fiber } command in interface Ethernet interface. You can use the
view to switch between the optical and electrical interfaces. For details about the view to switch between the optical and elec
enable { copper | fiber } command, refer to
SR6600 Routers User Manual User Manual.
Use optical transceivers provided by Use optical transceivers provided by HP only. The device may be incompatible with other

optical transceivers and thus displays alarms automatically. optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the swapping" a module refers to first using the remove slot slot-number

the module, and then manually pulling it out, or inserting the module into its slot without the module, and then manually pulling it out, or inserting the module into its slot without the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the powering off the device. For details about the remove slot command, refer to
Management in the System Volume
LEDs
Figure 1-18 FIP-110 LEDs
(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0) (1) LED for 10/100/1000 Mbps electrical Ethernet interface 0 (GE0)
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1) (2) LED for 10/100/1000 Mbps electrical Ethernet interface 1 (GE1)
(3) Run LED (RUN)
(4) 1000 Mbps optical Ethernet interface LED (SFP1) (4) 1000 Mbps optical Ethernet interface LED (SFP1)
(5) 1000 Mbps optical Ethernet interface LED (SFP0) Mbps optical Ethernet interface LED (SFP0)
Table 1-21 Description of FIP Description of FIP-110 LEDs
LED
RUN (green)
Item
4 MIMs supported at the same time
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.) 45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Supported
75 W
Supported
} command, refer to Ethernet Interfaces in the Access Volume
System Volume of HP SR6600 Routers User Manual.
Status
Off Off
Slow blinking (1 Hz) Slow blinking (1 Hz)
Fast blinking (8 Hz) Fast blinking (8 Hz)
Specification Specification
electrical interface.
trical interfaces. For details about the combo
only. The device may be incompatible with other
No power input is available or the FIP-110 has failed. No power input is available or the FIP
The FIP-110 is working normally. 110 is working normally.
Application program is being loaded (in this case, never power Application program is being loaded (in this case, never power
off the device or hot-swap the FIP
may be damaged) or the FIP-110 is not working.
} command in interface
Access Volume of HP
command to stop
command, refer to Device
Meaning Meaning
swap the FIP-110; otherwise, the FIP-110
110 is not working.