HP A6616 Installation Manual page 86

SubCard is inserted in Frame 0 Slot 7 SubSlot 7, type is HIM-8GBE.
%Apr 26 15:35:29:162 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=7;(Src Slot[7])
Slot 7/1 Plug In Successfully!
Press Enter. The following message appears on the terminal screen:
System is busy with VIU configuration recovery, please wait a moment...
<HP>
This means the HIM has been successfully installed.
2) If the router does not recognize the HIM or if the HIM installation failed, the following
information appears on the terminal screen:
<HP>
%Apr 26 15:36:09:404 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=7;(Src Slot[7])
Card in Slot 7 Sublot 1 can not be recognized !
<HP>
The device supports hot-swapping of HIMs.

When installing a HIM, use proper force and keep the HIM in the vertical position to avoid

damage to components on the card.
The configurations (if any) made on a HIM before you remove the FIP will not be automatically

restored upon reinsertion after you restart the FIP. To keep the configurations, make sure that
the HIM is in position before you restart or reinsert the FIP.
Removing a HIM
Be sure to run the remove slot slot-number subslot subslot-number command before

removing a HIM while the router is operating.
If you have run this command but do not want to remove the HIM, you can use the undo

remove slot command to cancel the operation.
It is unnecessary to run the undo remove slot command after you remove a HIM and insert it

again.
Follow these steps to remove a HIM:
Step1 Face the front panel of the router.
Step2 Locate the HIM to be removed.
Step3 Loosen the two captive screws on the HIM counterclockwise with a flat-blade screwdriver until
all spring pressure is released.