HP A6616 Installation Manual page 89

Card in Slot 7 Sublot 1 can not be recognized !
<HP>
The device supports hot-swapping of MIMs.

When installing a MIM, use proper force and keep the MIM in the vertical position to avoid

damage to components on the card.
Removing a MIM
Be sure to run the remove slot slot-number subslot subslot-number command before

removing a MIM while the router is operating.
If you have run this command but do not want to remove the MIM, you can use the undo

remove slot command to cancel the operation.
It is unnecessary to execute the undo remove slot command after you remove a MIM and

insert it again.
Follow these steps to remove a MIM:
Step1 Face the front panel of the router.
Step2 Locate the MIM to be removed.
Step3 Remove the fastening screws on the MIM counterclockwise with a flat-blade screwdriver.
Figure 4-34 Loosen the fastening screws
Step4 Holding the handle of the MIM, gently pull out the MIM along the slide rails.