HP A6616 Installation Manual page 91

Figure 4-36 Connect the console cable
(1) Console port
(4) Serial interface on the configuration terminal
Connecting the AUX Port to a Modem
The AUX port is usually used for remote configuration or dial backup. In this case, you need to
connect the local modem to the remote modem through PSTN and then to the remote device.
Follow these steps to connect the AUX port with an AUX cable.
Step1 Plug the RJ-45 connector of an AUX cable into the AUX port on the router.
Step2 Plug the DB-25 (male) or DB-9 (male) connector into the serial interface on the analog modem.
Figure 4-37 Connect the AUX cable
(1) AUX port
(3) AUX cable
(5) DB-25 (male) or DB-9 (male) connector
(2) RJ-45 connector
(2) RJ-45 connector
(4) Modem
(3) Console cable
(5) DB-9 (female) connector