Technical Specifications - HP A6616 Installation Manual

RSE-X1
Front view
Figure 1-8 Front view of RSE-X1
(1) Captive screw
(3) SMB coaxial clock interface (reserved)
(5) CF card eject button
(7) CF LED (CF)
(9) USB interface 1 (1) (device mode)
(11) Link state/data reception & transmission LED (LINK/ACT)
(12) Management Ethernet interface (MANAGEMENT) (10/100/1000BASE-T)
(13) Console port (CONSOLE)
(15) Active LED of the RSE-X1 (ACT)
(17) Run LED (RUN)

Technical specifications

Table 1-10 Technical specifications for the RSE-X1
Processor
Number of processor cores
Flash
Memory type and size
NVRAM
Console port
AUX port
Management Ethernet interface
CF card
USB interfaces
Reset button
Dimensions (H × W × D)
Power consumption
Hot swapping
Item
MIPS 1GHz
2
4 MB
DDR2 SDRAM
128 KB
1 (9600 bps to 115200 bps, 9600 bps by default)
1 (9600 bps to 115200 bps, 9600 bps by default)
1 (10Base-T/100Base-TX/1000Base-T)
cards less than 256 MB are not supported)
2 (USB 0: Type A connector, operating in the host mode; USB 1:
Type B connector, operating in the device mode)
1
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
75 W
Supported
(2) Ejector lever
(4) RESET button (RESET)
(6) CF card slot
(8) USB interface 0 (0) (host mode)
(10) USB interface 1 LED (USB)
(14) AUX port (AUX)
(16) Power management alarm LED (PALM)
(18) Alarm LED (ALM)
2 GB (default, two memory modules)
2 GB (maximum)
256 MB by default for the built-in CF card
256 MB, 512 MB, or 1 GB for an optional external CF card (CF
Specification