HP A6616 Installation Manual page 74

Figure 4-12 Insert the RPE
Step6 Fasten the captive screws clockwise with a Philips screwdriver. Fasten the captive screws clockwise with a Philips screwdriver.
Figure 4-13 Fasten the captive screws on the RPE
Step7 Turn on the power switch of the router if the router is powered off. Turn on the power switch of the router if the router is powered off.
Step8 After the RPE-X1 is powered o
(at 1 Hz) after the RPE-X1 application is loaded. This means that the RPE
Insert the RPE-X1 into the slot
Fasten the captive screws on the RPE-X1
X1 is powered on, the RUN LED (green) flashes fast (at 8 Hz). It flashes slowly n, the RUN LED (green) flashes fast (at 8 Hz). It flashes slowly
X1 application is loaded. This means that the RPE-X1 runs normally. X1 runs normally.