HP A6616 Installation Manual page 160

Symptom 3
Symptom
The ALM LED is solid on or blinking, which indicates that the router is faulty.
Example 1

The ALM LED is on when the CPU is overheated. The system gives the following information:
%Jun 25 14:38:45:444 2007 HP DRVMSG/3/TempCritical:
CPU temperature critical in Slot 3, index is 1.
Example 2

The ALM LED is on when the system power is insufficient. The system gives the following
information:
%Apr
DRVMSG/1/InSufficientPwr:
No sufficient power, failed to power on slot 3.
Example 3

The ALM LED is on when one of the redundant power modules configured based on Table 1-6
in Chapter 1 "Router Overview" is faulty. The system gives the following information:
%Apr 26
FAILURE:
Redundant
unit(s).
The power-supply policy redundant module-count command can be used to specify the
number of redundant power modules. The display power-supply command can be used to
show the system power information.
For example, if the display power-supply command is used during a 1+1 power redundancy
failure, the system gives the following information:
<HP>display
supply
System
1
System
System
watts
System
watts
System Power
System
watts
Power No.
-------------------------------------
26
16:16:49:518 2000
power-supply
Config
Actual Redundant-module
Power
Power
Used
Power
Type Watts
12:07:42:320
HP DRVMSG/1/REDUNDANT
failed,
Redundant-module
Total
Redundance
: 625
Usable
State
2000
POWER-SUPPLY
left
power-
: 0
:
:
watts
:
HP
0
:
650
0
25