Removing The Jbod Control Board - Supermicro SC946LE1C-R1K66JBOD User Manual

Chassis SC946L JBOD User's Manual

Removing the JBOD Control Board

The CB3 JBOD Control Board is mounted on a tray near the rear of the chassis. Note:
This procedure should only be performed by a qualified technician, in consultation with the
Supermicro Technical Support team.
1. Power down the system as described in Section 3.1.
2. Remove the power supply modules.
3. Loosen the power supply holding bracket by removing the thumbscrew on the right side
of the chassis, near the cover thumbscrew. Slide the bracket toward the left side of the
chassis and lift up.
Figure 3-12. Power Supply Bracket Thumbscrew, Chassis Right Side
Power Supply Bracket Thumbscrew
Figure 3-13. Power Supply Holding Bracket
46
Power Supply
Holding Bracket