Connecting The Flow Switch; Connection Of Chlorine Measuring Cell; Service Measures On The Unit; Opening The Casing - Bayrol PoolManager Chlorine User Manual

49.6.2

Connecting the flow switch

Also see the section Flow monitoring.
Terminal Function
[2+] Supply voltage
[2 ] Signal output
[2-] Ground (GND)
TIP
Connecting a reed contact
If a simple reed contact or other potential free contact is
being used instead of an the inductive proximity switch,
then it can be connected to the terminals [2 ] and [2 - ].
49.6.3

Connection of chlorine measuring cell

INFO
This section applies for the model
PoolManager O2 only.
®
Terminal Function
[1 RE] Reference electrode
(Ag/AgCl)
[1 CE] Counter electrode (platinum)
Working electrode (gold)
[1 WE] Working electrode (gold)
INFO
Electrode connection
RE and CE are connected to a BNC socket via adapter
cable. The chlorine measuring cell's glass electrode is
connected to it. This is a standard redox electrode
containing the reference electrode (RE) and the
counter electrode (platinum round end, CE).
The blue connection cable for the working electrode
50
50.1
1. Firmly press the hinge on the right side out and to the right.
Cable colour
Brown
Signal output
Blue
2. Remove the cover plate and unhook the hinge on the bottom.
3. Swing the casing cover open to the left.
Cable colour
Signal output
4. To close the casing, reverse this procedure.
black
orange
50.2
The terminal box cover is anchored by four screws. Loosen the four
Blue
screws and remove the terminal box cover.
When closing, tighten the screws enough that there is a reliable seal.
(WE) is linked directly with the chlorine measuring cell's
gold electrode.

Service measures on the unit

Opening the casing

IMPORTANT NOTICE!
Open on the right
Never open the casing on the left side, as damage may
otherwise occur.
Always open on the right side!

Opening the terminal box

89