Set-Up Flow Chart - Emerson Unidrive M700 User Manual

5.9

Set-up flow chart

Start
Connect all drives
together using
approved cable /
connectors /
switches
Ensure each drive
Is correctly
grounded
Ensure segment
lengths no longer
than maximum
limits.
Ensure that there
are no circular
loops between
devices/switches
Ensure the correct
cable types are
used
Perform cable
tests
Configure the IP
address, subnet
mask and default
gateway
Ensure PC is on
the same subnet
or the default
gateway on the
drive & PC are set
SI-Ethernet User Guide
Issue: 1
See Chapter 4
See Chapter 4
See Chapter 4
Note: Redundant
systems require
specialist hardware.
See Chapter 4
A dedicated
Ethernet cable
tester Is
recommended.
See Chapter 5
Any changes
made will require a
module reset to be
activated
Pr MM.007 = On
PING all drives
from a command
See Chapter 5
prompt to test
connections
Save module
See Chapter 5
settings on drive.
END
19