Emerson Unidrive M700 User Manual page 53

6.1.4 Menu 10 – Easy Mode Cyclic Data
The menus specified here allow up to 3 transmit and 3 receive cyclic links to be
configured. Each receive link can have its own timeout configured with an additional
custom action.
For greater control advanced cyclic links can be configured using the cyclic link editor
within Machine Control Studio.
Base link parameters
Link Profile
Tx1 S.10.010
Tx2 S.10.020
Tx3 S.10.030
Rx1 S.10.040
Rx2 S.10.050
Rx3 S.10.060
* Required if Type set to "unicast"
S.10.001
Minimum
Default
Type
Display Format
Coding
This parameter is used to enable or disable the Easy Mode protocol interface.
S.10.002
Minimum
Default
Type
Display Format
Coding
This parameter is used to perform a warm reset of the protocol interface. When set and
the protocol has reset, the parameter will be reset to zero (Off).
SI-Ethernet User Guide
Issue: 1
Src/Dest
Link No. Par Count
Par
S.10.011 S.10.012
S.10.021 S.10.022
S.10.031 S.10.032
S.10.041 S.10.042
S.10.051 S.10.052
S.10.061 S.10.062
Enable
0 Maximum
1 Units
1 Bit User Save Update Rate
None Decimal Places
RW, BU
Reset
0 Maximum
0 Units
1 Bit Volatile Update Rate
None Decimal Places
RW, NC
Type IP Address
S.10.013 S.10.14
S.10.023 S.10.24
S.10.033 S.10.34
S.10.043 S.10.044
S.10.053 S.10.054
S.10.063 S.10.064
1
Background read
0
1
Background read
0
Rate
S.10.015* S.10.016
S.10.025* S.10.026
S.10.035* S.10.036
n/a n/a
n/a n/a
n/a n/a
53