Mechanical Installation - Emerson Unidrive M700 User Manual

3

Mechanical installation

CAUTION: power down the drive before installing / removing option modules. Failure to
do so may result in damage to the product. Refer to the relevant Safety Information
section in the appropriate drive manual.
CAUTION
Figure 3-1 Installation of an SI option module on Unidrive M200 to M400 (sizes 2 to 4)
• With the option module tilted slightly backwards, align and locate the two holes in the rear of the
option module onto the two tabs (1) on the drive.
• Place the option module onto the drive as shown in (2) until the module clicks into place. The
terminal cover on the drive holds the option module in place, so this must be put back on.
Option modules can only be installed on drives that have the option module slot
NOTE
functionality.
Figure 3-1 above is for illustration only, the actual option module may be different to the
NOTE
one shown.
10
2
1
SI-Ethernet User Guide
Issue: 1