Initial Setup Data - GE DigitalFlow GS868 Startup Manual

March 2008

Initial Setup Data

Model #
Software Vers.
Serial #
Channel 1
Channel Status
Measure Mode
1-Channel
Site Label
Site Message
System Units English
Pressure Units
Stopwatch Total.
Channel 1
Gas Equation Standard
Vol. Units
Vol. Time Units
Vol. Dec. Digits
Totalizer Units
Tot. Dec. Digits
Mass Flow
Mass Flow Time
MDOT Dec. Dig.
Mass Totalizer
Mass Dec. Dig.
Channel 1
Std. Trans. #
Spec. Trans. #
Spec. Trans. Hz
Spec. Trans. Tw
-2
After the Model GS868 flowmeter has been installed, some initial
setup data must be entered via the User Program, prior to operation.
Record that information in Table B-2 below.
Table B-2: Initial Setup Data
General Information
Measurement Method - ACTIV
Off Burst
Skan S/M
System Parameters - SYSTEM
Metric
Auto Manual
1-Channel and 2-Channel
Actual
Pipe/Transducer Parameters - PIPE
Note: table is continued on next page.
Reference
Date
Z Dimension
Channel 2
Channel Status
Measure Mode Skan
2-Channel
Chan.1 Label
Chan. 1 Message
Chan. 2 Label
Chan. 2 Message
Channel 2 (if applicable)
Gas Equation Standard
Vol. Units
Vol. Time Units
Vol. Dec. Digits
Totalizer Units
Tot. Dec. Digits
Mass Flow
Mass Flow Time
MDOT Dec. Dig.
Mass Totalizer
Mass Dec. Dig.
Channel 2 (if applicable)
Std. Trans. #
Spec. Trans. #
Spec. Trans. Hz
Spec. Trans. Tw
Off Burst
S/M
Actual
Data Records