Jd1 / Rs232 Smart Port Computer Interface; Usb Computer Interface - ABB DPA UPScale ST40 User Manual

6.4.2 JD1 / RS232 smart port computer interface

The Computer Interface JD1 (4) located on the distribution part is an intelligent RS232 serial port that
allows the UPS to be connected to a computer. The connector JD1 is a standard D-Type, 9-pin,
female.
The optional WAVEMON software allows the computer to monitor the mains voltage and the UPS
status continuously.
In the event of any changes, the computer terminal will display a message.
(For details see ABB's optional monitoring package: WAVEMON).

6.4.3 USB computer interface

The Computer Interface USB (5) is located on the distribution part and is in parallel with the
intelligent RS232 serial port JD1.
The optional WAVEMON software allows the computer to monitor the mains voltage and the UPS
status continuously.
In the event of any changes, the computer terminal will display a message.
(For details see ABB's optional monitoring package: WAVEMON).
Fig 6.4.3-1: Distribution Interfaces
Modifications reserved
Page 50/79
JR2 / RS485
(Not used ) foreseen for RJ45 Plug
X2
Customer interface on Phoenix terminals
= Potential free contacts
X1
Customer inputs (detail see chapter 6.4.2 )
JD1
Smart port RS232 / sub D9/ female,
PC interface
USB
PC interface
SNMP
Slot for optional SNMP card ONLY
Modem
Slot for optional modem/ethernet card ONLY