Interfacing; Smart Port Jd1 On Each Module (Serial Rs 232 / Sub D9 / Male) - ABB CONCEPTPOWER CLASSIC DPA-50 User Manual

3.1 INTERFACING

Each UPS cabinet is provided with communication port on each single module and a communication card, which
provides system information
On the Module :

JD1 / RS232 Sub D9 / male: SMART PORT Interface (one per Module)
Communication card (next to the distribution) :

Input Interfaces

Output Interfaces :

JD11 / RS232 Sub D9 / female :

JD12 / RS232 Sub D9 / male

USB
3.1.1

SMART PORT JD1 on each module (Serial RS 232 / Sub D9 / male)

The SMART PORT JD1 located on the Modules itself is an intelligent RS 232 serial port that allows the UPS
Module to be connected to a computer. The connector is a standard D-Type, 9-pin, male.
When installed the optional SMART PORT, the software WAVEMON allows the computer to monitor the
mains voltage and the UPS status continuously.
In the event of any changes the computer terminal will display a message.
(For details see our Monitoring Package: WAVEMON ).
The fig. 1. shows how to connect a PC to the UPS with different Sub-D connectors.
a) Interface Cable (UPS End)
(9-Pin, D-Type Male)
Connects to UPS
SMART PORT
Figure 1. Connector Cable - PC Serial Port with 9-Pin Connection
X1 (Phoenix terminals)
X2, X3, X4 DRY PORTs ,volt-free contacts (Phoenix terminals)
Interface (UPS system to computer)
Interface for Multidrop connection between several UPS cabinets
Interface (UPS system to computer
1
2
3
5
.
.
9
04-3008_S3_ABB_OPMCPDPA-S2_GB_121202
Printed in Switzerland – Modifications reserved
)
Interface cable (Computer End)
(9-Pin, D-Type Female)
1
2
Connects to
3
Computer
5
.
.
9
Section-3
Page 2/4 ABB