Interfacing; Smart Port Jd1 (Serial Rs 232 / Sub D9 / Female) And Usb Port - ABB PowerScale CABINET A User Manual

3.1 INTERFACING

Each UPS is provided with communication port and a communication card, which provides system information
STANDARD ITEMS
RS232 on Sub-D9 port
Customer Interfaces :
Inputs DRY PORT
RJ45 port
Power Management Display (PMD)
OPTIONAL ITEMS
Relay card + USB Including:
Customer Interfaces:
5 output DRY PORTS
RS232 on USB port
SNMP Card (slot already included)

3.1.1 SMART PORT JD1 (SERIAL RS 232 / SUB D9 / FEMALE) AND USB PORT

The SMART PORT JD1 and USB port located on the UPS itself is an intelligent RS 232 serial port that allows the
UPS to be connected to a computer. The connector is a standard D-Type, 9-pin, female, and the USB is a standard
USB port.
The software WAVEMON allows the computer to monitor the mains voltage and the UPS status continuously.
In the event of any changes the computer terminal will display a message. (For details see our Monitoring
Package: WAVEMON ).
The Fig. 1.1 shows how to connect a PC to the UPS with different Sub-D connectors.
a)Interface Cable (UPS End)
(9-Pin, D-Type female)
Connects UPS
to SMART PORT
Figure 1
For monitoring and integration in network management
1 Remote Shut down [EMERGENCY OFF (Normally closed)]
1 GEN-ON (Normally open)
1 Programmable Customer's Inputs (Normally open)
1 Temp. Sensor for Battery Control
1 12 vdc source (max. 250 mA)
For multidrop purpose
LCD display

Common alarm

Load on bypass

Battery low

Load on inverter

Mains failure
For remote signalling and automatic computer shutdown
SNMP card
For monitoring and integration in network management
1
2
3
5
.
.
.
9
Connector Cable - PC Serial Port with 9-Pin Connection
04-3004_S3_OPM_ABB_POWERSCALE_10-50kVA_EN_150113.doc
Printed in Switzerland – Modifications reserved
Interface cable (Computer End)
(9-Pin, D-Type male)
1
2
3
Connects to
Computer
5
.
.
.
9
Section-3
Page 2/6 ABB