Tektronix P5200A Instruction Manual page 32

Accessories
Small Hook Tip (TASH)
Use the small hook tip for making
connections to small conductors such as
component leads.
Screw the small hook tip onto the TATP test
probe. To use the hook tip, hold the probe
body and pull the tip shield back. Hook the
tip onto the circuit and release the shield.
WARNING. To reduce the risk of shock
when measuring voltages above 1000 V,
always keep your fingers behind the tactile
indicator.
Maximum ratings:
2300 V CAT I*
1000 V CAT II
* See Specifications for the Over-Voltage
Transient (OVT) rating for the probe that you
are using.
Large Hook Tip (TALH)
Use the large hook tip when working with
larger components such as bolt terminals
and bus bars typically found in power
distribution equipment.
Screw the large hook tip onto the TATP test
probe and then clamp the hook tip onto the
circuit.
WARNING. To reduce the risk of shock
when measuring voltages above 1000 V,
always keep your fingers behind the tactile
indicator.
Maximum ratings:
2300 V CAT I*
1000 V CAT II
* See Specifications for the Over-Voltage
Transient (OVT) rating for the probe that you
are using.
13 P5200A Series High Voltage Differential Probes Instruction Manual