Tektronix P5200A Instruction Manual page 31

Test Probes (TATP)
Use the test probes to browse multiple test
points or to connect the test leads to the
hook tips.
1. The test probe tip is a 6-32 threaded post
that accepts the large and small hook
tips provided with the probe.
2. The finger guard provides protection
when the hook tips are not being used.
Keep your fingers behind the finger
guard whenever possible to reduce the
risk of a shock from the circuit under test.
3. Connect the back end of the test probe
to the input test leads of the probe.
Maximum ratings:
2300 V CAT I*
1000 V CAT II
* See Specifications for the Over-Voltage
Transient (OVT) rating for the probe that you
are using.
WARNING. To prevent arc flash, use
caution when probing circuits with raised
components. Avoid getting the metal shell
between components of different potentials.
Use TASH for probing in hard to reach areas.
WARNING. To prevent arc flash, do not use
the test probe or hook tips on CAT III circuits.
To probe CAT III circuits, use the AC280-FL,
AC283-FL, or AC285-FL.
P5200A Series High Voltage Differential Probes Instruction Manual
Accessories
12