IDEC FC5A-F2M2 User Manual page 85

C PID M
ONFIGURING ODULE USING
Offset from
the control
register
CH0 CH1
(7) +186 +396 ARW (Anti-Reset Windup)
Output Manipulated
(8) +187 +397
Variable Rate-of-Change
(9) +188 +398 Alarm 1 Value
(10) +189 +399 Alarm 2 Value
(11) +190 +400 Alarm 3 Value
(12) +191 +401 Alarm 4 Value
(13) +192 +402 Alarm 5 Value
(14) +193 +403 Alarm 6 Value
(15) +194 +404 Alarm 7 Value
(16) +195 +405 Alarm 8 Value
Output Manipulated
(17) +197 +407
Variable Upper Limit
Output Manipulated
(18) +198 +408
Variable Lower Limit
Cooling Proportional
(19) +199 –
Band
(20) +200 – Overlap/Dead Band
Valid Range for Alarm 1 to Alarm 8 Value
Alarm Type
Upper Limit Alarm
Lower Limit Alarm
Upper/Lower Limits Alarm
Upper/Lower Limit Range Alarm
Process High Alarm
Process Low Alarm
Upper Limit Alarm with Standby
Lower Limit Alarm with Standby
Upper/Lower Limits Alarm with Standby
*1: When input is voltage/current, full scale is the linear conversion span.
*2: When input is voltage/current, the valid range is the linear conversion minimum value to linear conversion maximum
value.
6-20
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
W LDR
IND
Parameter
0 to 100%
0 to 100%/sec
Refer to the valid range for alarm 1 to alarm 8 values
shown in the following table.
When output type is voltage:
Output manipulated variable lower limit to 100%
When output type is current:
Output manipulated variable lower limit to 105%
When output type is voltage:
0% to output manipulated variable upper limit
When output type is current:
-5% to output manipulated variable upper limit
0.0 to 10.0 times
(Cooling proportional band is the multiplication of
heating proportional band)
When input range unit is Celsius:
-200.0 to 200.0°C
When input range unit is Fahrenheit:
-200.0 to 200.0°F
When input is voltage or current:
-2000 to 2000
–(Full scale) to full scale *1
–(Full scale) to full scale *1
0 to full scale *1
0 to full scale *1
Input range lower limit to input range upper limit *2
Input range lower limit to input range upper limit *2
–(Full scale) to full scale *1
–(Full scale) to full scale *1
0 to full scale *1
FC5A MicroSmart PID Module User's Manual FC9Y-B1283
Description
Valid Range
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W