IDEC FC5A-F2M2 User Manual page 80

Offset from
the control
register
CH0 CH1
Output Manipulated
(14) +32 +109
Variable Rate-of-Change
Output ON/OFF
(15) +61 +138
Hysteresis
Manual Mode Output
(16) +21 +24
Manipulated Variable
Loop Break Alarm (LA)
(17) +35 +112
Time
Loop Break Alarm (LA)
(18) +36 +113
Span
(19) +95 – Cooling Method
Cooling Proportional
(20) +48 –
Band
Cooling Output ON/OFF
(21) +98 –
Hysteresis
(22) +50 – Overlap/Dead Band
Program Control Mode
(23) +91 +168
Start Type
Set Point (SP) when
(24) +96 +173
Program Control Starts
(25) +92 +169 Step Time Unit
(26) +93 +170 Program End Action
(27) +97 +174 Number of Repeats
FC5A MicroSmart PID Module User's Manual FC9Y-B1283
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
C
ONFIGURING
Parameter
0 to 100%/sec
When input range unit is Celsius:
0.1 to 100.0°C
When input range unit is Fahrenheit:
0.1 to 100.0°F
When input is voltage or current:
1 to 1000
When heating/cooling control is disabled:
Output manipulated variable lower limit to output
manipulated variable upper limit
When heating/cooling control is enabled:
- Cooling output manipulated variable upper limit to
heating output manipulated variable upper limit
0 to 200 minutes
When input range unit is Celsius:
0 to 150 °C
(Range with a decimal point: 0.0 to 150.0°C)
When input range unit is Fahrenheit:
0 to 150 °F
(Range with a decimal point: 0.0 to 150.0°F)
When input is voltage or current:
0 to 1500
0: Air cooling
1: Oil cooling
2: Water cooling
0.0 to 10.0 times
(Cooling proportional band is the product of this value
and the heating proportional band)
When input range unit is Celsius:
0.1 to 100.0°C
When input range unit is Fahrenheit:
0.1 to 100.0°F
When input is voltage or current:
1 to 1000
When input range unit is Celsius:
-200.0 to 200.0°C
When input range unit is Fahrenheit:
-200.0 to 200.0°F
When input is voltage or current:
-2000 to 2000
0: PV start
1: PVR start
2: SP start
When input is thermocouple/resistance thermometer:
Set point (SP) lower limit to set point (SP) upper limit
When input is voltage or current:
Linear conversion min. to linear conversion max.
0: Minute
1: Second
0: Terminate program control
1: Continue program control (Repeat)
2: Hold program control
0 to 10000 times
PID M W
ODULE USING
Setting Range
LDR
IND
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
6-15